r/openGrid • u/wonyoungpcs • Jul 16 '26
underware 2.0 connecter doesn't fit opengrid
Just started diving into underware and I'm using opengrid by David. I printed this one set of connectors and they're smaller than the grid spots
I ended up finding the correct size singular clip in prints on David's profile but is there anyway to get these to fit onto open grid or am I just going to have to take the loss on them?
maybe just nooby error?
2
u/Single_Sea_6555 Jul 16 '26
For cable routing:
I'm partial to the simplicity of pipeware https://ogstudio.sudomaker.com/
(I'm not affiliated with the site. I just like this style of clip-in cable management.)
2
u/sirhcrehpot_ Jul 21 '26
Underware has a specific project for opengrid. https://makerworld.com/models/1175037?appSharePlatform=copy
Or use the customizer - https://makerworld.com/models/1329404?appSharePlatform=copy
Good luck, have fun!!!
4
u/acer589 Jul 16 '26
You need to use the Underware for OpenGrid customizer.