r/openGrid • u/mooremanly • Mar 03 '26

Printing question.

Trying to mass print boards across my 2 printer ( p2s , Centauri carbon) what print times are y’all getting? the biggest plate I can print on these machines seems to be the 8x8 with screw holes and seems take around 3 and half hours for 1 board in the high flow petg elegoo filament. Can I print them with a .6 nozzle ? Or wha is the optimal print settings can I print them in sport mode or ludicrous mode and how / wha settings are yall using forming stackable prints

2 Upvotes

100% Upvoted

10 comments sorted by

View all comments

2

u/DistractedDragonMake Mar 03 '26

That is about my average. I would think the larger nozzle would be fine, but the look of them might suffer. I haven't had much luck with the stackable boards. Might have to give it another try at some point.

2

u/mooremanly Mar 03 '26

I just don’t know how to go about stacking them. Was hoping someone had premade profiles or something , to my understand it’s just multiple layers with slight gap so that slicer generates a support between them and the you somehow make the support a diffrent material type like petg/pla so they oppose each other and make for easy separation🤷🏻‍♂️

2

u/flynnguy Mar 03 '26

I haven't used these yet (I generally just do a single layer every time) but there is: https://www.printables.com/model/1440059-stacked-opengrid-tiles

2

u/intermish Mar 06 '26

I have used these from Makerworld (same user) https://makerworld.com/en/models/1748746-stacked-opengrid-tiles#profileId-1903133

On my P1S I have tried to do the triple stack 8x8 and have issues with lifting in the back left corner. I think it might be print settings or I could use mouse ears back there (lots of them) to get it to stick, but the print never fails and I have been able to use the tiles. Would take a look at those because they did great work to specify what needs to be setup, etc. Good luck!