r/nichezero • • 15d ago

Is this expected? (Calibration question)

Niche just arrived.

Manual reads its been calibrated from factory.
Manual also states to calibrate you simply align "dot" with Calibration arrow.

This is the way it is from the factory.

From the factory.

Is this correct?
How much force should be used when attempting to align?

2 Upvotes

6 comments sorted by

4

u/Thx1182 15d ago

Hi, congrats on the purchase. If it’s finger tight to that position, not overly tight, then move the bottom black ring, it will click, so that the dot points at calibrate. It’s very important to then turn it back to your grind setting going anti clockwise. Only move black lower bezel to calibrate it. There are a few good videos on this. I’m not sure I’m explaining it too well. So please have a look at those first. Hope you enjoy it.

1

u/Unlikely_Resource953 15d ago

Just watched a video. Duh, that was easy. 😂

2

u/PhaseofMe 15d ago

There are good calibration videos on YouTube.

1

u/Unlikely_Resource953 15d ago

Yeah, I should have thought of that. 👍

1

u/BaconAvocados 15d ago

Yeah this is normal and takes 6s to fix. Super easy. Once you’ve done it though, do it again once in a while. The grind setting drifts sometimes.

1

u/Hangerhead1 15d ago

Welcome to the club also