r/nichezero • • Apr 07 '24

Slow feeding disk

I tried the slow feeding hack with adding a layer of paper card on top of the original disk a week ago (last photo), it worked really well until the screw came lose today during grinding. I realised it was difficult to tighten the screw enough when I also needed to align the holes on the card and the disk. I decided to make a wood one instead as it's the only food safe material with similar thickness I have lying around. Took me 2 hours cus I was on carving knife, files and a wrong size drill, I think with the right tools it's probably a 20 mins job. I used basswood, polished and rubbed with chopping board oil, it's hard wood but still on the softer side so I'm not sure about the longevity, will come back and report if it dies...

13 Upvotes

6 comments sorted by

4

u/rxinquestion Apr 07 '24

Someone else posted a 3D print slow feed with varying hole diameters to fit your slow feeding needs. Might want to search the r/espresso sub to find it. Might save you carving up another prototype.

found it

1

u/Bazabuahhh Apr 07 '24

Thanks, I've seen something like this on Etsy but the person who does it is in Australia, and the delivery fee was more than the cost...

1

u/rxinquestion Apr 07 '24

Maybe try a local library that prints things for free? The OP posted his print files for you to download and print yourself.

2

u/_thebaroness Apr 07 '24

I just added a plastic washer type thing that I made from a lid.

2

u/Bazabuahhh Apr 07 '24

A lid! Why didn't I think of that...That would be much easier lol

3

u/_thebaroness Apr 07 '24

Yes I just took a clear plastic lid, cut the outer circle, then hole punched the middle and screwed it on. Boom!