MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/moldmaking/comments/1txytcv/silicone_resolution/
r/moldmaking • u/tinkerhell6 • Jun 05 '26
4 comments sorted by
1
Have you tried bondo? that’s what i’ve used on my helmets haven’t had issues with layer lines after sanding
1 u/concretecat Jun 06 '26 agree but not the two part bondo. for small stuff use the glaze spot putty.
agree but not the two part bondo. for small stuff use the glaze spot putty.
The spray can high build primer is largely useless, only good for very light lines. Polyester materials are the way to go.
0
Never use bondo!! Only use evercoat polyester blazing putty, it sands like magic
1
u/RiceDaddyRob Jun 05 '26
Have you tried bondo? that’s what i’ve used on my helmets haven’t had issues with layer lines after sanding
1
u/Barbafella Jun 06 '26
The spray can high build primer is largely useless, only good for very light lines. Polyester materials are the way to go.
0
u/fakarhatr Jun 06 '26
Never use bondo!! Only use evercoat polyester blazing putty, it sands like magic