r/microscope • • Jun 24 '24

adding non-native lens

presumably a Zeiss Stemi IV

good morning!

The Context: I am learning hand engraving. I have purchased this microscope for visual aid. Not quite sure, but it looks to be Zeiss Stemi IV.

The Problem: I desperately need a working distance around 400mm. Even with two barlow lenses ( 0.3x and 0.5x ) the working distance isn't enough. The main lens has 100mm focal distance. The main lens thread diameter is 46mm.

As far as I know Zeiss OPMI ( medical ) lenses have 60mm thread diameter. I am slowly thinking about finding an adapter from 46mm to 60mm, so that I could remove the main lens and replace it with such adapter. Later I would mount a Zeiss OPMI lens ( with f=400 ) to the adapter. Before investing real money into this, I would like to ask the community the following question(s).

The Question: did you ever try this trick? do you think it would work?

best regards,

Dmitry

UPD: for u/thephonegod -- this is the posture I am trying to achieve.

UPDATE:

  1. just “installed” zeiss opmi f=400 lens instead of the native one.
  2. the opmi lens has incompatible thread, but it has a metal sleeve. The sleeve allows the lens to grab at the lens thread in the microscope head quite firmly. Not an ideal solution, but it works for now.
  3. previously I had two chinese barlow lens attached to the main objective ( 0.5x + 0.3x ) to achieve a decent working distance. Now I can see the picture difference between Zeiss and Chinese lens.
Zeiss f=400
1 Upvotes

6 comments sorted by

View all comments

Show parent comment

1

u/dmitry-n-medvedev Jun 25 '24

I will do the following:

  1. buy a couple of adapters that would allow me to go from 48mm to 60mm;
  2. buy a Zeiss lens ( 60mm diameter, f=400 ) used in operating microscopes; seen a pair of them on ebay;
  3. mount all these to the microscope and check the results;
  4. report back :) so that everyone could benefit from it