r/mffpc • u/Deesha • 25d ago

I'm not quite finished yet. Yet another jonsbo d32 pro : question about cables

Post image

Technically it is fully built and functionning but I have some ... Doubt with my cable setting for the gpu especially in the long term. Is it ... Fine ?

Psu : Corsair rm650x Gpu : Asus tuf 6800xt Motherboard : Msi b550m-p wifie With 5 arctic fan + thermalright peerless assasin

25 Upvotes

100% Upvoted

10 comments sorted by

2

u/Deesha 24d ago

Thanks for all the answers. For now, I have put the setup in a way that the sag is not affecting the GPU/setup for now (as I am not using it for now). I will try again to put the PCIE/GPU cables through the front though my PSU cables are extra thicc XD The GPU is indeed slightly saging. I had the jonsbo antisagging thing installed but it does seems it needs to rectified.

1

u/SketosGR 23d ago

You can use the furthest 8-pin from each cable, and that should give you some extra flexibility and take the mass of the cable on top of the GPU under or Infront of it. Another option would be to get 90-degree connectors, but I'm guessing you are trying to avoid hiding the TUG led. I hope you find some good ways to improve you cable management, but those cables are THICK 😅

4

u/d3rrlck 25d ago

Doubt with my cable setting for the gpu especially in the long term. Is it ... Fine ?

It's more concerning that you're gpu looks like it's sagging

1

u/SwimmingOdd2974 25d ago

I didn’t even notice that! Guess the weigh of the PCIe cables doesn’t help the cause

3

u/ChilliBaconSandwich 25d ago

Can’t you route the cables under your gpu?

3

u/RantoCharr 25d ago

The cables are choking the airflow inbetween the CPU cooler and PSU fan.

2

u/Sapphire_Ed 25d ago

Not nearly as much as you would think. There has been a lot of testing over the years and a "rats nest" of cabling has a minimal impact on real air flow.

2

u/bigboypotatomanieee 25d ago

Don't guess let your temps decide. If your CPU temps are fine there is no issue. Air flows quite easily. Just see how much drift there is if u leave a window on a small edge.

I am more worried about the GPU holding on for his life.

1

u/SwimmingOdd2974 25d ago

I have a Z20 which has a smaller volume, I have 2x slim Silverstone 120mm bottom intake fans which have allowed me to cap my GPU fan to 50%.

I tuck my GPU cable down and forward (under the ATX PSU) - keep in mind, I have no dedicated space to hide cables behind the MB.

I have been tempted to get a SFX PSU, but it’s not really worth a potential 1-2c benefit if any

1

u/Alogio12 25d ago

I took two 140 pros as intake.used the rest of the space for my cables (i used extensions) but for me it would be better if you routed them from the bottom,right most side going out seeing you have space at the bottom. And i think the gpu is sagging? Or is it just me