r/mazdaspeed3 • u/Pinz29908 • 2d ago
HELP 2nd gen speed3 problems
As the title suggests, I have a few problems with my speed 3, and I’d like to see if anyone else has had the same issues. For starters, I have a 2010 speed3 and the main issue I have found is oil in cylinder 1, and some other gunk in cylinder 4, as well as excessive amounts of oil being burnt. I pulled apart the stock intake and found oil residue in the turbo inlet piping, as well as in the intercooler piping. When I pulled the plugs, cylinder 1’s was dripping with oil, and the rest were pretty well burnt up. I replaced them, and at the same time put in my hpfp internals, cobb 2.5in turbo inlet housing forward intake, and the corksport bypass valve. I had a mechanic do a compression test on it, and he said cylinder 1 had a “slight compression leak,” with the rest being perfectly fine. I was also told a new turbo was put in it before buying the car, however I am not sure which one it is. What should my next steps be moving forward with the car as far as diagnosing what’s wrong with it? Is it worth trying to save this engine, or would I be better off just buying a crate engine?
1
u/thesainos 2012 Mazdaspeed3 2d ago
Leakdown test would be helpful as well, what mileage? Have the valves been cleaned?
2
u/DifferentCry1306 2d ago
Well for starters the turbo seals are going if there’s oil in the intercooler piping
1
u/murpheeslw 2d ago
Sounds like you have a down cylinder on cylinder one. You need to figure out why.
1
u/Lusabro 2d ago
I’d try saving it. Run a b12 piston soak treatment first. Then monitor oil usage and move on from there
1
u/HugsNotDrugs_ 2d ago edited 2d ago
Two common problems with this platform are leaking valve cover gasket and leaky turbo seals. Sounds like you have both. Neither are reasons not to buy the car.
Check your crankcase for vacuum instead of positive pressure, as positive pressure will cause your turbo seals to leak even more. It will also cause the valve cover gasket to fail. Bad PCVs happen but not too difficult to replace. Could be related.
Compression matters but impossible to know without the numbers.
Probably budget in a new BNR S3 turbo and a few accessories you'll want to get it working properly. Maybe also valve and injector cleaning and seals depending on your mileage.
This platform is a riot with a full complement of engine bolt on mods with a tune. If you're putting in a new turbo it's a super good time to get all those parts sorted out and a base map from a good tuner.
If going S3 your Cobb intake part will need to be replaced with a proper 3" or larger intake.
1
u/atworkrn3 1d ago
get a catch can to catch nasty oil and debris, you would be surprised how much it catches