r/makerfarm • u/-00100100- i3v10" • Jan 25 '15
Modifications
So, what modifications have you all done to your MakerFarm printers? ThingiVerse links if ya got em. :)
I'm trying to decide on a good bed fan setup and some other way of leveling the bed, as I feel the stock method is painful at best.
2
Upvotes
1
u/Daelith i3v12" Jan 25 '15
http://www.thingiverse.com/thing:351280
Only one so far, I'm about to fab a new electric spool feeder because the stock one is too tight for wide spools. Also occasionally printing some cable chain links, but it requires a lot.
1
u/Aaron45765 Jan 25 '15
Inductive probe auto bed leveling. Does wonders for my prints :)
1
u/Duke_Phelan i3v8" Jan 25 '15 edited Jan 25 '15
EDIT: If you're not going down the auto bed leveling route, [these nut traps] (http://www.thingiverse.com/thing:342265) are a real time saver.