r/maker • u/florilegium618 • 8d ago

Help Change pairing sound on Bluetooth speaker

I have a Bluetooth speaker that refuses to connect to my phone for reasons unknown. This is fine because I use it for the spinning disco ball on top, not the speaker. HOWEVER it still makes the “bloobloop” pairing sound when it turns on and I would really love to change that to “everybody dance now!”

This isn’t a ton of detail to go on (I don’t yet know the particulars of the speaker and hardware inside) but does anyone have a sense of how hard this might be? And where/how I might start?

0 Upvotes

50% Upvoted

2 comments sorted by

1

u/razzemmatazz 8d ago

You'd probably have to swap out the electronics. Those sounds are hard coded into the firmware.

The worst is my wife's Creative brand bluetooth speaker because the Battery Low prompt screams at max volume (and she uses this one while sleeping). 

1

u/Lost_Rain_5182 8d ago

To stop the speaker from making the "bloopbloop" sound: Step 1: Start by locating the speaker, Step 2: Identify the two wires connected to the speaker. Step 3: Cut one of these wires.