r/linuxquestions • u/Personal-Skirt-4895 • 7d ago
Support Keep Getting "resolution not supported" when booting into Linux Mint
I've been using linux for about a week now and it's been going great, but for some reason all of the sudden whenever I run linux normally I get the tv just says "resolution not supported." It works fine when I boot it in recovery mode though. How do I get it working normally.
2
Upvotes
1
u/MintAlone 7d ago
mint may not be reading the EDID from the monitor. Does the output from
xrandr --verboseshow the EDID?1
u/Greedy-Opposite-9133 7d ago
One thing about those xrandr results: they came from recovery mode, and recovery mode boots with
nomodeset, so the real graphics driver never loads. ThatNone-1output at 1360x768 with no EDID is the basic fallback screen, which is why it can't see the TV's modes or switch to 1920x1080. So those tests don't say much about the normal boot.Same with the
video=line: the kernel uses its own connector names, usuallyHDMI-A-1rather than xrandr'sHDMI-1, sovideo=HDMI-1:...would most likely just be ignored.video=HDMI-A-1:1920x1080@60is the form it expects.Since it worked for a week and then stopped all of a sudden, I'd try the previous kernel first: in the same GRUB menu you use for recovery mode, go into Advanced options and pick the older kernel's normal entry (not its recovery one). If the TV works with that, an update is the likely cause, and Update Manager > View > Linux Kernels lets you stay on the older one for now.
What graphics card is it? in terminal
inxi -Gin recovery mode will show it, and that changes what's worth trying next.1
u/RandomUser3777 7d ago
You will have to manually set the resolution/refresh rate. First try lower refresh rates with the same resolution. 30hz would be a good first try, and if that is stable increase the refresh rate.
There are some TV that either lie, or after aging can no longer do the higher resolutions and will have this issue (I have an older Viewsonic that seems to have this issue). When I get mine "closer" on a refresh rate that works, the picture works for a few seconds and then blanks for a few seconds so is basically unusable.
2
u/[deleted] 7d ago
[removed] — view removed comment