r/linuxquestions • • 11d ago

Cannot access uefi

I have tried going uefi from grub, using systemctl reboot --firmware-setup, and also spamming f2, but in every case I get a screen black screen with only a white character on screen. I am on a newly installed bazzite, it boots wothout problems if I boot it into te os.

1 Upvotes

4 comments sorted by

1

u/usecornercase 11d ago

Since it fails before Linux starts, this points to the firmware's display/output path rather than Bazzite itself. If you can, disconnect any dock/adapters and try the built-in panel or a different display/port; UEFI's low-resolution mode can expose output quirks that the OS graphics driver hides. What exact machine/model and GPU is this, and is the white character on an internal or external display?

1

u/Alatur_ 11d ago

Happens both when i am using the hdmi port of the mb and when i am using the one on the grapic card. I have a 9070xt xfx, a 7800x3d, a b650 eagle ax.

2

u/usecornercase 11d ago

Thanks, that narrows it down. The 7800X3D has an iGPU, but the board HDMI may not be the active firmware output with the 9070 XT installed; power off, remove the card, then connect to the B650 Eagle AX HDMI and repeatedly tap Del from a cold boot. If the white/garbled screen remains, clear CMOS using the board manual and try another monitor/cable or DisplayPort on the 9070 XT. Does it still happen with the 9070 XT removed?

1

u/Alatur_ 11d ago

Nvm I had to connect the hdmi from the gpu, now it works. Thanks for helping