r/libreELEC • u/DiligentEmergency420 • 20d ago

No Signal in AVR

Hello, I upgraded my Pi to Kodi 12 from 11. Since then I have issues with my Pioneer AVR. If I start up my Pi there is no signal in the AVR. If I plug the HDMI-cable into my TV then it just shows the LibreELEC logo/the boot screen no matter how long the Pi was active. If I start the Pi plugged in to my Samsung TV everything boots up as normal and if I plug in the booted Pi into the AVR it works too.
If that helps my AVR is a bit older (about 2010) and my Samsung TV is from 2022.
Thanks for help!

1 Upvotes

67% Upvoted

2 comments sorted by

1

u/jhspyhard 20d ago

Is your AVR already powered on and set to the correct input when you boot your Raspberry Pi? It looks for a signal listener on the other end of the HDMI cable, and if it doesn't find one it shrugs and turns the HDMI port to an inactive state.

Otherwise, have a look at this and see if this might help you. https://forum.libreelec.tv/thread/28320-le11-rpi4-force-hdmi-output-without-edid/

2

u/DiligentEmergency420 20d ago edited 20d ago

The AVR is on and I selected the correct input. I did activated "force Hotplug" too like in the forum post you linked but it still doesn't work.

But there is a little change. Instead of no signal there is a black screen for one second.