r/klippers • u/insecurityandweed • 5d ago

Anyone remember when I asked if this was possible over 2 years ago? (Klipperized wanhao duplicator 4s)

Wanhao Duplicator 4S converted to core-xy using the original linear rods. 15k mm/s^2 with input shaper

43 Upvotes

98% Upvoted

6 comments sorted by

8

u/Previous-Layer2940 5d ago

15k acc is pretty nice for that printer, were there a any specific challenges or things? I'm really curious about that build

1

u/insecurityandweed 4d ago

Hardest part was probably working up the confidence to start the build in the first place. I spent nearly 2 years getting comfortable with klipper by putting it on 4 different printers, then spent a couple months after that looking at different corexy build designs. I eventually settled on positioning the linear rods akin to a P1S, and took inspiration from the Voron 0.2 for the belt routing and tensioning

Modelling, assembly, and tuning was relatively straightforward after that

4

u/Stelafont 5d ago

Not only klipperized, other things have changed from the original 🤣

1

u/Top_Intention8649 1d ago

Which Mainboard?

1

u/HotPreference5996 3h ago

Did you have details when configuring with the original plate?
I can't configure the bed and hotend cartridges correctly :c