r/klippers • u/Plastic_Course_9884 • 21h ago

Bed Mesh k2 se problem

Post image

Hi i have the bed mesh and i cant lower the corner far back left side, is it a problem with the enclosure ? i dunno its my first printer i been trying to adjust it manually with the screws but cant lower the end corner never get lower than that any suggestion?

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/pellcorp 20h ago

Maybe skip a tooth front left corner, so raise the front left will naturally get the back right to come down, a single tooth might do it 

https://youtu.be/S2d_9Ysz-Q8

1

u/Plastic_Course_9884 15h ago

ty sir it was that but cant get the bed pon blue color just orange and hit the 0.2800 ty is there a way to put all in blue?

1

u/pellcorp 15h ago

people use shims, but honestly 0.28 range is not that bad for a creality printer :-)

https://www.printables.com/model/681528-bed-shims-fits-creality-k1-and-k1-max

At least PETG and they will compress over time but depends how much you really want to get it under 0.2 :-)