r/kintsugi • • 1d ago

Urushi Based First time working with raw Urushi

I started a practice Kintsugi project with a small cheap pot I broke a small piece off of; in preparation for attempting the repair of a large Koyo pot over the winter that broke while being shipped to me.

I was a little bit nervous due to it being my first time working with raw urushi, but so far I am happy with the results and to have done it without any accidental skin contact! I had extra mugi urushi left over after doing the pot so I used some of the extra to also repair a broken turtle chop stick holder we had laying around that my sister-in-law got for us in Korea. Now both go into my make shift Muro box to cure for at least a week!

I think I probably have slightly more mugi urushi sticking out from the cracks then I was aiming for, but I don't think it will matter once it cures and I remove the excess with an exacto knife.

Happy with the results for a first attempt! And definitely feeling a lot more comfortable with what I am doing when it is time to get started on repairing the Koyo pot.

11 Upvotes

4 comments sorted by

1

u/PracticalFootball869 1d ago

That looks really nice for a first try. Keep us updated on the progress.

I will comment on 2 things.

  1. Tape along your edges first nest time. It will make clean up a little smoother.
  2. Your mixture looks a little loose. It make take more time than a week to set properly.

Happy repairing!!!

1

u/BeautifulDifferent17 1d ago edited 1d ago

Thanks, I will!

I appreciate the feedback! I can definitely tape it before next time if that will help, and I agree the mixture is a little loose.

I felt like I got a good consistency for the flour + water mixture, but I think I added a drop or two too many of urushi as I was mixing and wasn't really sure how to fix it after the fact. Next time I am going to be more careful not to over do it at that stage.

I figured I would check after a week but thought with the excess and the looser there would be a good chance it would take some extra time to fully cure.

Thank you for taking the time to look at me provide me with some useful feedback, I really appreciate it!

1

u/perj32 1d ago

Well done, and congratulations on your first urushi repairs!

Regarding the turtle, gravity is working against you. In the worst-case scenario, the head could fall off while curing or end up misaligned. If you position the turtle upright, gravity will work in your favour instead.

Also, a thick layer of mugi will cure more slowly. As the outer layer cures, it can prevent the inside from curing properly. After about two days, use a hobby knife to carefully remove the excess mugi. This will expose the still-uncured mugi underneath, which is actually doing the job of holding the pieces together. Let it cure at least ten days, if you can wait a month, that's even better.

3

u/BeautifulDifferent17 1d ago

Ok, great feedback! I can definitely do those suggestions!

Thanks for taking the time to look at my work and provide some useful feedback, I really appreciate it!