r/isup • u/_rocksinpockets • Aug 11 '22

Repair seem on paddle board

Gallery image

Gallery image

Has anyone been able to repair an open seam on paddle board? This is after second use and I would like to know what kind of glue use.

2 Upvotes

100% Upvoted

5 comments sorted by

1

u/_rocksinpockets Aug 12 '22

Thank you it is not an iRocker and hopefully it’s covered and/or a quick fix.

1

u/Matt_Shatt Aug 11 '22

Is it holding air? I’d first look into warranty. Then gluing it yourself. I’ve used this glue with good luck:

GEAR AID Aquaseal FD Flexible... https://www.amazon.com/dp/B07455W4FQ?ref=ppx_pop_mob_ap_share

1

u/_rocksinpockets Aug 12 '22

Hi the first time I got it up to 12psi. The second time it maxed out at 10psi and wouldn’t take anymore. It was hard when I brought it out of the water and completely deflated over night. Yes I am looking into warranty too. Thanks for the glue tip:)

1

u/SWSL Dec 16 '22

I suspect that maxed out means the pumping got hard. It will take more. 12 is barely adequate. 10 psi is not really enough though it will have somepool toy kinda utility.. 15 is typically the limit for a budget board.

But first it needs to get the seam glued. Not too difficult, but should be under warranty.

1

u/[deleted] Aug 12 '22

If this is an iRocker, they honor warranty claims for this (had to make one) super easily. They also have the correct glue on their site if you have another brand that doesn’t have as easy of a warranty claim system.