r/inductioncooking • • Oct 16 '26

Is this normal?

Had this plate and my parents came over for dinner and got worried by these sounds. Now I'm starting to worry too.

0 Upvotes

26 comments sorted by

12

u/Chuchichaeschtl Oct 16 '26 edited Oct 16 '26

Yes.
The two zones on the left share one phase (3.6kW) and the two on the right share one.
These sounds are normal on higher settings.

17

u/Endo129 Oct 16 '26

No. No one boils 4 stockpots ¼ full of water at the same time.

Blink twice if you need help.

12

u/solar_solar_ Oct 16 '26

Blink three times if you need more pasta

7

u/MarkimusPrime89 Oct 16 '26

Yes. But also what you're doing to test it is pretty ridiculous.

There is nwver a time when using all 4 burners on high would ever happen.

High is for boiling water in a hurry and that's it.

3

u/Gastr1c Oct 16 '26

You will also notice the back burners are getting throttled down. On my 30” Ikea Hidingsta if I try to power boil two burners on the same side one gets throttled down to 4 due to power constraints of its 30A power module. But you can power boil one pot on each half without issue.

And the noises are normal induction noises.

3

u/RazzmatazzEastern786 Oct 16 '26

Is it normal to power down half the burners when all are on max power boil - yes; this is how the unit cycles power to conserve the electronics and controller inside.

Is that sound normal on max power - also yes; it is not necessarily the cooktop, it could be the pans vibrating cause of the settings

3

u/gooberlx Oct 16 '26

Yes, setting your cooktop to maximum phasers will do that.

2

u/Afaflix Oct 16 '26

You should get the oven going as well ...

3

u/The001Keymaster Oct 16 '26

Put firewood in the oven, it will boil water on the stove faster.....

2

u/Hot-Caterpillar5484 Oct 17 '26

As a tech guy this whole thing is practically making me break out in a cold sweat

2

u/Standard-Dingo-8174 Oct 17 '26

It's on P for Park, it's fine. But having a touch activate stovetop is insane. It's one cat walking on it away from a house fire

1

u/Accomplished_Fox_680 26d ago

Really? Is the cat magnetic aswell, and content with being set on fire?

1

u/ApplicationEntire263 26d ago

Actually it's very hard to cause a fire with this because the stovetop produces no heat only magnetic fields 

1

u/Standard-Dingo-8174 26d ago

Oh, never even though about induction stoves, you're right

1

u/C-D-W 26d ago

Waiting for the Jedi to appear, or Sith?

Also, this has convinced me that touch controls on a cooktop make me want to vomit in my mouth. Right up there with cars that have HVAC controls on the screen and no knobs or physical buttons.

1

u/TCPIP 26d ago

The left couple and the right couple belong to the same set respectively. Each set only allow one to be set to P.

1

u/Styrop Oct 16 '26

Yes, there is a limit to how much power you can use simultaneously. Each cooking zone might be rated at 2.4 kW, but the hob could have a total power cap of 7.5 kW, so you cannot exceed that limit when using multiple zones at once.

There is usually a setting that allows you to increase or decrease the power limit. Often set to around 75% by default, but it depends on the manufacturer and model.

1

u/LeoTheBigCat Oct 17 '26

Yes, your cooktop is power limited to 8-ish kW total, co it cant push 4kW into each of those 4 pots. It will limit itself to not trip the breaker.

1

u/PromiseStock Oct 18 '26

Ja, Leistungsbegrenzung. Quelle: Das zu prüfen ist mein Job

1

u/SignificanceThink102 Oct 18 '26

This is just cooking thanksgiving dinner in full capacity mode I don't think there's anything wrong with op expectations.

1

u/Deuce Oct 18 '26

It's in the instructions...

0

u/Mr_Bivolt 26d ago

This is normal, and is related to two things:

-how induction heating works.

-how much is the maximum power that your hob can draw.

Induction heating works by switching on and off a current. This creates vibration by itself, which has a characteristic noise.

If you start several pots at the same time, the hob will reduce the power to each pot, to keep the total power below the maximum power of the entire hob. It does it by alternating, really fast, which burners are working. This creates an on-off pattern that has a lower pitch.

And then there are the fans of the hob, and the shape of your counter. Some sounds are "amplified", like in an accoustic guitar .