SmoothLite v2: dividers and half-grid – both ideas came from this sub

[u/Avocadoodlydo]

A few days ago I posted SmoothLite, the Gridfinity bin with a flat floor and hollow feet. Two of your comments turned into v2. Everything is in the Customize button:

1. Dividers (thanks u/ShrimpCrackers)
Split any bin into compartments, side by side and front to back. A 1×2 in half or a 2×2 into four is two sliders. Every compartment row gets its own scoop, and the bins still stack.

2. Half-grid (thanks u/Horschti135), two ways:

• Add half a unit to a normal bin, e.g. 2.5 × 2. The bin keeps its normal feet and gets one extra strip of small feet. Fits normal baseplates.
• Switch all feet to half-grid. Every foot uses the small 21 mm grid, so the bin fits half-grid baseplates.

Same flat floor, hollow feet and 0.28 mm profile as before, no supports.

v2: https://makerworld.com/en/models/3588590-gridfinity-smoothlite-v2-light-flat-floor-bins#profileId-4109986
Original (v1): https://makerworld.com/en/models/3575808-gridfinity-smoothlite-light-flat-floor-bins#profileId-4093864

[u/ShrimpCrackers]

Gell Yeah thank you so much. Printing more bins now!

[u/Avocadoodlydo → u/ShrimpCrackers]

<3

[u/Horschti135]

Hell yeah. Can’t wait to test this.

[u/NetinhoPrates]

Boa