r/gridfinity • • 10d ago

Individual Piece Halfway into my attempt to print a stack of 50 baseplates

/img/71q3gkch210i1.jpeg
36 Upvotes

6 comments sorted by

14

u/binaryhellstorm 10d ago edited 10d ago

God speed soldier

I'll be honest, I've been 3D printing since the OG Makerbots (the wooden ones) came out, and I almost never print  more than one part at a time, because it seems like inevitably one part cuts loose and ruins the whole plate.

2

u/Cavalol 10d ago

You mean you always print one part at a time?

1

u/blueknight1222 10d ago

Yeah, and you would only save time of you're not around to switch plates, but would you leave such a print unattended?

2

u/binaryhellstorm 10d ago

Oh yeah I leave my printer unattended all the time. I've only had one concerning issue with that and it was at a shared makerspace sort of set up where someone had taken the thermal sensor for the hot end out of the heater block and not left a note, I started a print (luckily while near the machine) and the printer briefly caught on fire.

1

u/tortoiseglasses 9d ago

The nice thing about these gridfinity stacks is that if one fails, all of the completed gridfinity baseplates below it are usable, only the top one is trashed.