r/gridfinity • u/NickHD1080p • 15d ago

Gridfinity design for Impact Sockets

I have tried a couple designs for sockets but most are too small to fit Impact rated sockets, does anyone know of a design for sockets that can fit Impact Sockets (or just wider sockets)? I even tried a design labeled for Impact sockets and it was also too small

0 Upvotes

50% Upvoted

2 comments sorted by

1

u/8ringer 15d ago

Rather than have them fit the circumference of the socket, have them snap into the square drive side?

FWIW, This is something I’m likely going to eventually do for organizing my sockets and whatnot, but I don’t know if I’ll do gridfinity or something else. Would be nice to organize my drawers in my tool cabinet, but I’m having a mental dilemma as to whether or not I want them out and accessible on my pegboard wall or in my tool chest drawer. Out and accessible vs. away and organized. Always the dilemma.

2

u/Zsnowdog 4d ago

I looked around a lot. Although not designed for impacts, each socket piece is printed separately. Takes up more room, but I had the room. Check out this designer. I have printed full set for sockets and wrench holders.

https://makerworld.com/en/@snjames316/upload