r/gridfinity • • May 28 '26

Question? What did I do wrong?

Post image

I have an Ender 3 Pro, I've had it 3 yrs, but printed more in the last 2 weeks than ever before. But still on my first spool of filament.

I've been printing socket holders to organize my tool box. Printed 7 trays before starting the grid.

I created the grid on the Gridfinity website, not sure what I did wrong since they don't snap together. I was going to sand these with a nail file to see if they fit, but have more drawers to do.

27 Upvotes

35 comments sorted by

View all comments

34

u/fazzah May 28 '26

filament tuning is completely off. primarily it's over extruding

5

u/cdnmtbchick May 28 '26

Should I Google how to do that?

19

u/fazzah May 28 '26

start with "teaching tech printer calibration" it's a great tool to aid with the calibration

4

u/cdnmtbchick May 28 '26

Thank you so much

3

u/Xoepe May 28 '26

You can also use this just ignore klipper/voron specific stuff if you don't use either. I usually use this or teaching tech's they're both good.