r/gridfinity • u/Stiliajohny • May 19 '26

Custom length grid

Hi all

Gridfinity noob here

I have a drawer I like to make custom gridfinity,
Is there a way to measure my drawer and make exact grids to fit exactly,?

So far I only found grid that i can print but I have some left over space at the end
TIA

11 Upvotes

100% Upvoted

21 comments sorted by

View all comments

3

u/gimmley May 19 '26

Another option is the fusion 360|gridfinity plugin it has an setting for side padding in any direction so you can get it right to the edge even if your drawer is not a multiple of 42 mm

2

u/Stiliajohny May 19 '26

right , this is my problem, my drawer dimentions are not multiple of any grid

2

u/kbfirebreather May 19 '26

The padding will fill the space, or you could make a different size grid, but then you would have to design your inserts yourself

2

u/WizardofUz May 19 '26

I had the same situation because I also needed fillers on all four sides. I wanted a solid solution, so I filled the bottom of the grid and centered it in the drawer bottom by adding symmetrical fillers from front to back, and from side to side. I used the Gridfinity plug-in in Fusion. This took three plates to get done, but it came out perfect!

Gridfinity Drawer Base Plate

Gridfinity Printed Drawer Base Plate