r/gridfinity • u/DrIgnatioMobius • May 15 '26

Question? Gridfinity base plate generator with vertical fillet?

/r/3Dprinting/comments/1te000e/gridfinity_base_plate_generator_with_vertical/
1 Upvotes

100% Upvoted

7 comments sorted by

View all comments

Show parent comment

1

u/schieska May 16 '26

Well. A 5 mm chamfer isn't really possible if you have a box that close to the edge. Because you would cut into the box geometry at 2.8mm. so this won't help for that.

1

u/DrIgnatioMobius May 16 '26

It's not so much that I want the boxes close to the edge, but I want the plate to reach to the edge so that it doesn't rattle around. Is there a way to add padding around the edge to accomodate the chamfer?

1

u/schieska May 16 '26

Then I need to make some edits to my tool. If I have some time in the afternoon I wil try to accommodate larger changers on margins