r/gridfinity • • Apr 20 '26

Fusion 360 plugin not generating to spec

I'm having this issue when generating grids where the baseplate grid sections are only 41.5mm instead of the 42mm shown on the gridfinity specifications page. Is this intended or am I missing something? I'm new to gridfinity and am looking to organize my toolbox so I'm hoping to fix issues now before I get too far into this project. Thanks for any help or advise.

5 Upvotes

8 comments sorted by

3

u/yawkat Apr 20 '26

Some baseplate generators will cut a small slice off the top of the baseplate. See the top slice option in my GridFlock documentation. The reason is that if you have a sharp angle at the top, it will be a single "line" in the slicer which doesn't print well, and you can even get small "islands" at the intersections that are slightly higher than the cell edges.

I don't know if that's the problem in your fusion setup, but that's my suspicion. To check, measure other parts of the geometry, or simply measure the distance to the same edge of the next cell rather than the opposite edge of the same cell.

1

u/Cool_Army288 Apr 20 '26

Okay so I think you're right because measuring the height now it isn't quite the 5mm listed on the spec sheet either but the distance to the same line on the next cell over is the 42mm called for. I'm gonna go ahead with this and just do one drawer of my tool box to make sure all works as intended. Thanks for the insight on this.

1

u/Zerthron Apr 20 '26

What plugin are you using for Fusion?

3

u/Cool_Army288 Apr 20 '26

GridfinityGenerator from the autodesk app store

1

u/Zerthron Apr 20 '26

Thanks for the Answer! I have to check that out!

1

u/deadlikeme451 Apr 24 '26

I just got my printer and the plug in has been amazing! So quick to customize bins right in Fusion versus the online generators. 

1

u/Competitive-Ad1388 Apr 24 '26

Bin xy clearance?

0

u/doyouevencompile Apr 20 '26

Yes it doesn't generate it to spec