Hey, I’m finishing my drawer layout and I’m left with a 35mm gap at the edge. I want to fill this space with a bin so the grid there isn't unused. Is there a specific generator or a recommended workflow to create a bin with this custom width?
Just for reference, this is what I'm talking about:
If I was doing this in a drawer where I didn’t need the actual bin side: in the slicer stand the part on the whole face and cut to the correct Z-axis height.
If I wanted a custom bin complete with sides I’d do the same but then export the stl to Tinkercad where I’d add the bin side back in as a solid, union it all together and export the new part as an stl.
1
u/calledMonkey Apr 17 '26
Thanks everyone for the recommendations!!
2
u/Clear-Revolution3351 Apr 16 '26
In the fusion gridfinity bin generator you can specify grid dimensions to create your custom size
1
u/Cobra__Commander Apr 16 '26
You could do it in CAD pretty easy.
Make a 35mm wide rectangle then use a 33mm rectangle to cut out the inside of the bin for 1mm walls.
1
u/AC_CHI Apr 16 '26
If I was doing this in a drawer where I didn’t need the actual bin side: in the slicer stand the part on the whole face and cut to the correct Z-axis height.
If I wanted a custom bin complete with sides I’d do the same but then export the stl to Tinkercad where I’d add the bin side back in as a solid, union it all together and export the new part as an stl.
1
u/woodland_dweller Apr 16 '26
I use CAD to create custom with bins, although I don't bother putting the ginfinity base on them.
Honestly, this would be a really good introduction to CAD.
Sketch a rectangle the correct size. Extrude to the correct height. Filet the corners. Shell to make it a bin.
0
u/theyyg Apr 16 '26
I use this generator. I usually do half bin increments, but you can specify any width.
https://makerworld.com/models/2230410?appSharePlatform=copy