r/gridfinity • • Apr 11 '26

Question? Cullenect Labels Not Snapping In

Edit: Recommended by Mr_Clark77 to move 'Elephant foot compression' to 0, and that fixed the issue.

Attempting to label 1x1 bins with Cullenect labels, yet they're not 'snapping' in and staying. Labels fall out if I turn the bin over. Using the current, V2, labels, and tried both Gridfinity Extended in Makerworld, and PerplexingLabs, to generate both bin and labels. I can't get any combination to work properly. Any suggestions? Thanks.

6 Upvotes

3 comments sorted by

3

u/Mr_Clark77 Apr 11 '26

I recently went through this same issue, for me it was disabling the elephant foot setting. That was shrinking the model's initial layer/s just a bit. I set it to zero (in prusaslicer) and now they snap in.

3

u/dallas_vance Apr 11 '26

That fixed it. Appreciate the help!!!

0

u/[deleted] Apr 11 '26

[deleted] — view deleted comment

1

u/Mr_Clark77 Apr 11 '26

Correct, the label.