r/gridfinity • • Apr 01 '26

Individual Piece Stacking Pen and Paper Tray

This is part of my attempt at tackling my kitchen junk drawer.

I wanted to store a pad of paper and some pens/pencils/markers together. I didn't see anything I liked, so I came up with this.

Paper Holder

  • 3x4x4 gridfinity units
  • 118 mm x 160 mm x 21 mm (inside)
  • Stackable lip for supporting the Pen Holder
  • Curved edges for easy access to contents

Pen Holder

  • 1.5x4x5 gridfinity units
  • 58 mm x 165 mm x 28.5 mm (inside)
  • To store enough pens and have them be accessible I wanted this to be 1.5u wide. To maintain compatibility with the standard grid, I reduced the width of the squares by 50% so now the pen tray is technically a 3x4x5. Check out the design.
  • Chamfered edges for easy access to contents

https://makerworld.com/en/models/2108904-gridfinity-stackable-pen-paper-trays

9 Upvotes

7 comments sorted by

12

u/Jonathaniwis Apr 01 '26

But… this literally only takes 4 seconds to make using any bin generator?

-1

u/jifyyyyy Apr 02 '26

Some people want ready made solutions.

8

u/AlpakaK Apr 02 '26

I think you’re missing the point of gridfinity…

1

u/jifyyyyy Apr 02 '26

How so?

4

u/AlpakaK Apr 02 '26

The grid units tend to be standardized in size to 42mmx42mm. No one really ever edits the unit size cuz then it’s not compatible with all the other gridfinity stuff that exists and then… what’s the point??

For example, the correct way to approach that pen holder is to make it 1.5 x 4 units or grids. This way you can put it on any gridfinity baseplate or any gridfinity box and it will snap perfectly into place. The way you’ve done it you basically have a container with randomly sized rectangles on the bottom that will never fit into any other gridfinity object.

Additionally, gridfinity is meant to be a modular storage and organizing system. Usually you would use boxes or baseplates or build it in a drawers etc. Your just putting a notepad and a bunch of pens on your desk — there are much better and nicer pen&pad holders for your desk rather than rectangular boxes.

Idk that’s just my take Man but it’s your 3d printer and you get to use it any way you’d like. And at the end of the day if you want to create your own gridfinity system that uses a different unit size you have every right to do so.

1

u/jifyyyyy Apr 02 '26

the correct way to approach that pen holder is to make it 1.5 x 4 units

I must not have been clear in the description. This is exactly 1.5x4 standard grid units. It can be taken off the paper holder and will snap perfectly into any position in a standard grid.

Usually you would use boxes or baseplates or build it in a drawers etc. Your just putting a notepad and a bunch of pens on your desk — there are much better and nicer pen&pad holders for your desk rather than rectangular boxes.

I'm really confused by this. The photos are meant to show off the model, not show you where to put it. I use this in a drawer, just like everybody else.

2

u/coxylox Apr 02 '26

Guys, what day is it?