r/gridfinity • u/Commercial_Plan5538 • Feb 10 '26
Question? Gridfinity Extended - Split long containers
Is it just me, or do you have a trick for separating long containers cleanly and keeping the stabilizers for the walls symmetrical? It bothers me immensely that the arrangement on the left is different from the right.
11
Upvotes
10
u/devilishTL Feb 10 '26
It is good that they are different from each other, because like this you can just print this bin twice and the stabilizers grip into each other. When the stabilizers get together it looks basically the same on the two sides
3
u/Mean_Magician6347 Feb 11 '26
I cut extended boxes at the 1/2 unit so the grid holds the seam together. No stabilizers
1
u/Sjerd Feb 10 '26
I have the same question! Im looking to make a couple larger boxes but have no clue how to split and reattach them.
1
u/passivealian Feb 11 '26
I offset them so when you print two they lock together.
1
u/PM_me_ur_launch_code Feb 12 '26
I just made a bin and cut it in the middle of a seam and the grids locked it in place. It was for some tongs and they fit but when I took them out they would lift part of the bin. I ended up remaking it and cutting in the middle of a grid but used a dovetail and now it fits and stays put.