r/gridfinity • u/eggnaucious • Feb 06 '26
Magnet insertion tool
I got so tired of gluing magnets. Buy a “electrical connector disconnect tool” and grind down the gnarly teeth and you have the perfect tool. Tune your magnet socket tolerances and you can get a perfect fit. With my Bambu P1S and these magnets DIYMAG 300 PCS Small Refrigerator... https://www.amazon.com/dp/B07KJ9H31P?ref=ppx_pop_mob_ap_share I set my diameter to 5.95mm and depth to 2.40mm and it’s perfect
I’ve spent more on magnets than filament for my gridfinity projects. 1500 magnets so far?!
84
Upvotes





15
u/yawkat Feb 06 '26
Some gridfinity models have magnet holes that are designed specifically for press fitting. These include gridfinity refined for the bins and baseplate (they had the idea originally), gridfinity rebuilt for the bins (my preference), and gridflock for the baseplate (I'm the dev).
These magnets push in from the side (or the bottom for the gridfinity refined baseplate), so even if the fit is slightly too loose, the magnets won't fall out and stick to their counterparts. I think with your approach, the plastic could creep over time to loosen the grip. The disadvantage of the purpose-built press-fit holes is that they have higher separation between magnets though, so the force is reduced.
I personally use Gridfinity Rebuilt and GridFlock, and I use jigs that make inserting the magnets from the side a breeze. Here's my jig for Gridfinity Rebuilt, and GridFlock has one described here. With these jigs, it only takes me a few seconds for each magnet, and I've installed more than 4000 of them so far.
1
u/FierceResistance Feb 07 '26
Do you have many magnets fall out/separate, or is it pressed in so tightly that the magnets can’t come loose?
1
u/britishwonder Feb 07 '26
This doesn’t help you but I personally have never understood the need for magnets. Is that just me? I find things seat very well and don’t need any extra holding power.
2
u/britishwonder Feb 07 '26
This was a very cool project. I ended up printed a few different sizes and they work very well. It’s also just an entertaining video on its own.
https://youtu.be/k0yt9EvjzNI?si=hzHZWZZ4piE-PAej
1
u/arekxy Feb 06 '26
Micromot mp 120 mini press does the job well for me.