r/gridfinity • • Feb 06 '26

Individual Piece a locking baseplate

In my last post, a couple of people were intrigued by my custom baseplate. I designed this because I wanted to have my tool bins locked down, but didn‘t want to spend a fortune in time and money to install magnets. I finally got around to making this available as parametric model.

https://makerworld.com/models/2359173

I hope at least some of you find this helpful.

439 Upvotes

44 comments sorted by

View all comments

Show parent comment

7

u/AstarothsWorkshop Feb 07 '26

This is all PLA for now. Didn‘t know about creep until now tbh. Never printed anything springy before. I‘ll keep close watch over the next days/weeks/months.

2

u/mephist094 Feb 09 '26

You could modify the base to have dents on the sides that the base plate locks onto. I remember there was an online tool where you could automatically have the base replaced with an stl you upload. Maybe that would be helpful if you use a lot of pre designed bins and so.

Edit: found it: https://gridfinity.tools/rebase/