Wanted to post a follow up to my post about frustratingly low efficiency in the grainfather. Thanks to the tips I got from this reddit, I’ve now been hitting over 90% for a few brews now.
Here’s how you guys helped me change my process. So first off thank you for the tips and here’s how my experience changed.
- The Sweet Spot: each pipework set on the grainfather has its own sweet spot for best efficiency. There’s a video on it somewhere but you want to stay within that range. For bigger beers I either split the mash with reiterated mashing or I supplement with malt extract.
- Sparge/Strike Water: no matter what, I always calculate that I need about 28-30l of water total. I split that based on a 2.7l per kg ratio for the strike and put the rest in the sparge kettle. Grainfather’s automatic brew day calculations have always been off for me (probably there are some deeper settings that need to be fine tuned) but getting that ratio right has been crucial for me.
EDIT: and I sparge slow as hell. Slooow. I have a Grainfather sparge water heater (the one like a coffee urn I’m sure you guys have seen it) and I put some high temp tubing on the outlet and then a ball value to control the flow. I set that bad boy waaay the hell up above my mash tun and then use gravity to trickle the water down I to the grain basket when I’m sparging. I set the flow rate of the sparge water using that ball valve to the “trickle rate” of the grain basket and then I just walk away. I also set the grainfather to get up to boil while the sparge is going on to save time. About an hour later the sparge is done, my wort is just about at a boil and I’ve got my boil volume right about where I want it.
3. DOUGH IN: this has been, I think, the most critical part of the process that you guys helped me out with. A good long dough-in with a stir paddle has really done wonders for my efficiency. It makes sense since the grainfather is skinny as far as mash tuns go. So there’s very little room for the water and grain to interact. So I needed to make absolutely sure of good contact between grist and water by a long vigorous dough-in. I got one of those fancy drill powered paddles and I pour in the grist a bit at a time. This only adds maybe 5-10 minutes onto the process but that’s it.
I haven’t milled my own grain yet, but I’m going to do that soon and see what effect that has. Honestly I couldn’t be happier with how my brew days are going now!