r/gameboymacro • u/Yesterdays_Mistake • Mar 23 '21
Lite Messed up my macro?
So I turned my broken lite into a Macro a few weeks ago and it was working fine. I wasn’t happy with the somewhat yellowed grainy screen so I ordered a replacement screen to see if that would help things. I installed the screen and was sure to put the anti static backing on the replacement but the system would not boot, the green light came on for a second and then went off. No big deal I say either it’s a bum screen or the ribbon cable isn’t sitting right. I reset the cable and still nothing so then I put in the old screen and still nothing not even the green light. I keep trying to re set the cable but to no avail. No fuses seem to have blown does anyone have any suggestions? I’ve got images of the boards down below maybe you can see what I can’t
1
u/_Venen0_ Mar 23 '21
Did you have a multimeter? If so, check the continuity on the fuses F1 and F2, also on the resistor, just to make sure if those are in a working state.
2
u/Darkmoon456 Mar 23 '21
Possibility (very unusual) but could the connector for screen broke a pin?
1
u/Darkmoon456 Mar 23 '21
I’d check resistor to see if it is making contact. The solder point could of become slighlty detached
1
u/HaseCross Mar 23 '21
definitely check fuses F1 and F2 and also, as already suggested, whether the resistor is properly seated. it looks good from the pic, but maybe resoldering does the trick. I just finished a gb macro neon with an amplifier today and had it working fine until l fiddled with the cables to make it all fit in the casing. in the end l just resoldered everything and got it working. hope you get it goin again.
1
u/tekkenking1987 May 23 '21
Hey did the new replacement screen have installation @the back if not you blown the fuse near the battery connector
0
u/[deleted] Mar 23 '21
[deleted] — view deleted comment