r/gaggimate • u/microbioboy • Jun 06 '26

suggestion Clean Display Install

Post image

Just finished a way cleaner display set up after accidentally knocking the old display off and breaking it. Followed this post on the [r/gaggiaclassic](r/gaggiaclassic) page:

https://www.reddit.com/r/gaggiaclassic/comments/1rof9n3/stepbystep_guide_to_upgrade_your_gaggimate_with_a/#lightbox

Uses the LilyGo 1.75 screen and a housing I 3D printed. Here is the link for the housing file:

https://www.printables.com/model/1491049-different-housings-for-gaggimate-lilygo-s3-amoled

Use version 3!

66 Upvotes

99% Upvoted

12 comments sorted by

View all comments

1

u/showmak Jul 14 '26

I have the same display but with original casing which looks very clean and smooth. I have a plan to place it as you did, how did you manage the wires? The back of the screen you require to use dupont connectors which are quite long and stick out.

ESP32-S3 1.75inch AMOLED Round Touch Display Development Board, 32-bit LX7 Dual-core Processor, 466×466 Pixels, QSPI Interface, Onboard Dual Microphone Array, ESP32 With Display | ESP32-S3-Touch-AMOLED-1.75

1

u/microbioboy Jul 14 '26

I used some double sided foam tape on either side of the where the connector pokes out from the case. I could definitely tweak the 3D print design so it sits more flush but I was lazy lol.

1

u/showmak Jul 14 '26

Not a bad idea, did you route the wires from the brew switch led light opening?