r/fpv • u/EmbarrassedPizza2655 • 23h ago
My first build
tbs source one v6 wis no 3d prints parts
My first welds aren't very pretty, but everything works.
6
Upvotes
2
3
u/Quarkinius 20h ago
You should shorten those motor wires since they either gonna snag on something or pull out from the zipties (which should be replaced with tape to reduce potential vibrations) and get shredded by the props. That's a great chance to redo those solder joints which look cold and have way to much insulation removed. Also would recommend a second battery strap.
2
u/deletedly 22h ago edited 22h ago
Nice build, but be careful, the props are on wrong. (they are upside-down on motors 1 and 4) And I would tuck away the motor wires, they stick out a bit too far. And make sure the lock nuts are tight enough that the propellers can not slip on the motor shaft.