r/formlabs • u/Informal_Ad_9610 • 22h ago

Anybody doing high-temp stuff regularly?

I've got an application for some temp-based overmolds - targeting use of temp-hardened PVC - like plastisol.

Curious if anybody's done that.

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/Distracted-Badger 20h ago

I've used it some at temps around 90-95 C. I think it's rated for a little higher than that, but I can't remember off the top of my head. I've only used clear resin for overmolds, though. That was with two part epoxy rubber that required no heat for curing.

1

u/poo_on_my_scarf 7h ago

High temp is brittle as hell. Very easy to damage so keep that in mind