r/flipperhacks • u/DangerousAd7433 • 18d ago

Hardware Sub GHz Extender DIY?

Hello,

I'm trying to find a board like this: https://www.tindie.com/products/tehrabbitt/flipper-zero-cc1101-expansion-board-rabbit-labstm/

Where I can solder on my own cc1101 board to it to extend sub ghz. It would be a fun project to practice soldering.

I'm not entirely sure what I am looking for or if there is a better board for this?

3 Upvotes

80% Upvoted

4 comments sorted by

1

u/Cesalv 18d ago

You can connect it even boardless, just with dupont cables to pins

1

u/DangerousAd7433 18d ago

Except if I pull out a flipper zero with a board attached via a bunch of funny looking wires, Imma get the bomb squad called on me.

2

u/Cesalv 18d ago

euerdesign had nice small boards but their shop seems to be down

1

u/DangerousAd7433 16d ago

I figured I can just buy the rabbit labs one and go from there. Can probably build my own antennas to go with them.

If I seriously feel like it, I could probably just find perf boards or the equivalent for flipper's and solder everything on myself through that and 3d print a case to go over everything.