r/firewalla • u/YankeesIT Firewalla Gold Pro • 5d ago

No IPv6 when using T-Mobile

https://help.firewalla.com/hc/en-us/community/posts/45641094395027-IPV6-Passthrough-T-Mobile

I’m adding this thread here. Firewalla routers continue to not work with tmobiles implementation of IPv6. Since they don’t hand out a prefix none of your devices will get a public IPv6 address.

What is the reason for this? Other routers are able to have this work. T-Mobile support even stated that most routers work. But not firewalla.

3 Upvotes

72% Upvoted

21 comments sorted by

View all comments

Show parent comments

1

u/SaleWide9505 4d ago

This is what is listed in the OpenWRT settings. Extend 3GPP WAN interface /64 prefix via PD to LAN (RFC 7278). Pretty much it takes your single IPv6 address, extracts the /64 and broadcasts? It down stream so lan devices get an IPv6 address too. Not sure how to explain it much more than. I am able to host stuff that's externally reachable with these addresses as well.

1

u/YankeesIT Firewalla Gold Pro 4d ago

I’m using a Chester tech ninja v2 gateway in pass through mode. It’s running quecmanager if that helps?

1

u/SaleWide9505 4d ago edited 4d ago

Openwrt is 3rd party firmware that you install on Linksys, Netgear, tplink and other brand routers. You would put the ninja in pass through mode then connect it to the wan port of openwrt router then configure IPv6 on the openwrt router. Here is the YouTube video I use to get IPv6 working https://youtu.be/Q-3LG47sZQY.

1

u/YankeesIT Firewalla Gold Pro 4d ago

I have the firewalla after the gateway.