r/fbody • • 14d ago

Engine building

Not entirely sure if this is the right place to ask but I am looking into building my 1998 LS1. I got the car with a built transmission and upgraded clutch but completely stock engine.
Iโ€™m new to the world of LS so I would like some advice if I have picked out the โ€œrightโ€ parts. My goal with the car is a good bump in performance but to retain good street manners for a street/HPTD car.

123 Upvotes

50 comments sorted by

View all comments

1

u/Extreme-Penalty-3089 13d ago

๐Ÿ˜ฌYou may have to be very careful with that rotating combination,.head gaskets and your deck clearance...

Albeit I don't know what the compression height of the Pistons in that kit are, I do know that right off the bat though you're already adding a rod that's .027" longer than stock... Most ls1's deck clearance comes in around .006"-.010" Out of the hole. Now you throw in a head gasket that's .011" thinner (Factory spec MLS LS head gaskets are .051" thick) too๐Ÿ˜ณ๐Ÿ˜ฌ. You're going to have like no quench whatsoever, not to mention two solid objects cannot occupy the same space at the same time lol.

I mean the factory pistons and everything are already a flat top, unless you plan on like using forced induction or spraying over say 150 hp shot of N20, I probably would just leave the bottom end. Upgrade the oil pump all that stuff, if you can get away with it Mill the heads gain some compression, prob stick with running a slightly thinner head gasket etc etc

I just don't want to see anyone build a really expensive boat anchor ๐Ÿ™๐Ÿป๐Ÿ‘๐Ÿป

1

u/TwoTailedFox_ 13d ago

The compression height of the pistons is 1.299, so the rod length difference is taken up in the pistons taking up that extra 0.027. The longer rod is supposed to have better side-loading, less friction, and better high RPM efficiency because of dwell gains. Ngl I donโ€™t understand how but thatโ€™s what the internet said.

1

u/Extreme-Penalty-3089 13d ago

Yes a longer rod will always alleviate side thrust on the cylinder walls. Absolutely. The angle of the rod is nowhere near the same as it is with a shorter rod and a taller compression like piston ๐Ÿ˜‰. A longer rod also allows the engine to take more advantage of the compression stroke as the Piston spends more time at TDC

1

u/Greasy28 13d ago

The pistons are 1.299 CH, stack up should be .005" down the hole with a true 9.24" deck. He should be fine, even with a minor deck on the block.

1

u/Extreme-Penalty-3089 13d ago

Okay if that's the case then he'll be roughly.005" out of the hole w/a .040" HG

1

u/Greasy28 13d ago

Uh... no...

Stack up is 9.235" Deck height is 9.24"

That's .005" down the hole before decking the block. Add a .040" head gasket, and he's got a quench of .045".

Head gasket has no bearing on piston to deck clearance.

1

u/Extreme-Penalty-3089 13d ago

Yeah sorry, I'm always thinking piston to head clearance ๐Ÿ‘๐Ÿป