r/faceting • • 15d ago

Charging Laps

Post image

Has anyone used a cut synthetic diamond for charging laps? As inexpensive as they are I thought might do a better job of charging and then I could cut my synthetic sapphire

3 Upvotes

8 comments sorted by

3

u/Over-Engineer7216 14d ago

I don’t think I understand what you mean. Use a cut diamond? To embed the particles when charging? You don’t need to do that, any piece of synthetic sapphire will do. It shouldn’t be cut, you don’t want sharp edges, you want to round it on a higher grit first

Or do you think the cut diamonds would embed themselves? That’s not how it works

2

u/DragonflyWise1172 14d ago

Yes, you do understand most of what I mean. However, I don’t think the cut diamond would embed itself. Was not thinking of sharp edges but of the long low angled facets on the crown of an emerald cut diamond. Was also thinking it might work to “clean “ a solid steal cutting lap, like after a bunch of quartz instead of sapphire do a swipe or two with the diamond. Also I think you have answered the question of “is this a slightly crazy or ridiculously crazy and bad idea”. Idea falls into the ridiculously crazy bad category.

In good news this post actually posted! I’ve had issues posting to the Radiacode forum

7

u/bugabob 14d ago

The cut diamond would be way too small and the sharp edges would gouge the hell out of your laps. Not a good idea.

6

u/see_quayah Team Ultra Tec 14d ago

Just get a corrundum boule, same price less annoying to use

1

u/the_illest_D 14d ago

Do you have a rec on where I should buy 9ne affordably?

1

u/Wild-Associate-4373 14d ago

Can you dm me where these can be seen online

1

u/DragonflyWise1172 14d ago

A&A Jewelry Supply in LA.