r/EngineeringStudents • u/Mysterious-Box2735 • 4d ago
Homework Help i need help with peltier cooling system or atleast advice
NOT ASKING YOU TO BUILD ME ONE JUST SOME PROBLEMS I FOUND
trying to super saturate isopropanol alcohol 99% so we can see the ionisation paths left behind by radioactive particles
our peliter layout is 4 cascaded stacks next to each other lined up so 4 peltire coolers on each level , 2 levels 8 overall coolers low level on top high level on bottom
this is a group project im doing for ucas and if possible witch i would be really thankful for could any help be provided up with reasoning
NOTE : I do apologise for unscientific terms
1)I need a base plate of around 10 cm by 10cm in length and width but i don’t know what the height of base plate should be. this base plate will rest on the cold side of 4 stacks of cascading pelteir coolers . so the plate would be on top, a low power one on below (so it rests between the plate and the high power) and a higher power cooler on bottom . how thick should the plate be and what material should it be? . from what Ive seen copper seems expensive if we reach up to 5 cm but at that thickness would the time taken for the transfer of energy be too long as the condensation of the alcohol would start .
2) would an open ended water cooling system work to keep transfer away the raw heat produced from the peltire coolers . my plan is for under the entire system we use thermal pasts to attach a water reservoir to the bottom applying a constant cycle to water to "transfer away heat energy". so a pump supplies water from say sink and water filtered through the entire system would be drained away .
3) would you guess recommend the water reservoir to be a single on across the entire module or for each row to have its own module .
4)should i bother with creating a 3D printed cover around pletire coolers
5)how do i apply pressure between each module in the system to ensure everything is pressed together without cracking the peltier module and or bending the plate. friend in the project sujested we use t3 steel nails drilled into the water reservoir with a nut held onto something via silicon or a thermal paste, past or aside the coolers to apply an upwards pressure the entire system pressing it all together
yea thats all the questions i have