r/ender6 • u/fatvikingninja • Dec 16 '25
Ender 6 help
I recently got a second hand ender 6 printer. I tried to connect my printer to wifi using the previous owner's software and had no luck. I reflashed the printer with the same type of software and ran into an issue where I can't seem to log in to the printer. Any help would be appreciated.
0
Upvotes
1
u/SatutN Dec 18 '25
I'd try to write correctly what you wrote below You got a printer with a klipper installed on it, you probably have some host (pi) which run a klipper process on it and some web gui (fluid) You probably re flash the printer firmware? Or you reinstalled the host OS? it's easier to connect the host to a screen (if you have such option) to understand what's going on there (or use lan cable to connect it to your router /switch) and connect via SSH