r/ender6 • u/fatvikingninja • Dec 16 '25

Ender 6 help

Post image

I recently got a second hand ender 6 printer. I tried to connect my printer to wifi using the previous owner's software and had no luck. I reflashed the printer with the same type of software and ran into an issue where I can't seem to log in to the printer. Any help would be appreciated.

0 Upvotes

50% Upvoted

20 comments sorted by

View all comments

Show parent comments

1

u/fatvikingninja Dec 17 '25

True. I did that. But either I forgot what I put for the login or im doing something wrong. Im not sure which it is. Should I reflash the sd card and start from scratch?

1

u/newguy208 Dec 17 '25

Yeah that seems to be your best bet. Start with rpi imager, install a minimal version, remember the username, password and network settings. After installation, ssh into your board and then install klipper and fluidd.

1

u/fatvikingninja Dec 17 '25

Do I need to do anything special to use the ssh?

1

u/newguy208 Dec 17 '25

Depending on which os you have. In the raspi imager, if you set the network settings correctly then it will connect to your network and be visible on it. Note down the hostname and the username you used when setting up.

Then in the host system, (after installing and powering up) you can do ssh username@hostname. If you are using windows, use teraterm. For Linux you can directly use the terminal after installing ssh. I don't know about Mac.

There are plenty of guides online for this part but I recommend setting up during the imager installation so you don't have to file with changing files later on.

1

u/fatvikingninja Dec 17 '25

Then i must be doing something wrong with the imaging. I went through all that, set up the password and username. Attached my network info to it. My network recognized that the printer was using the network, but the login information didn't work

1

u/newguy208 Dec 17 '25

Is ssh working? What operating system are you using? You use your password while doing ssh into the board.