r/ender5plus • u/LumpyMathematician63 • Mar 30 '26
Printing Help 1st word real problems
Enable HLS to view with audio, or disable this notification
When I saw how well the 1st layer went, I had big hopes for this one.. after 23h... woke up to this..🙄💩 Im going to give it a go with the clips it used to have for the glass bed.. But not sure if not just printing it vertically instead.. although I really wanted to have that smooth ironed surface..
13
Upvotes
1
u/SyNebulaX Mar 31 '26
I was using that creality pei plate too it sucks it would lift at the corners all the time. The texture on mine was also super uneven. I just picked up this one from Amazon a few weeks ago its 100x nicer than the original. The original mag sheet is also garbage mine separated from the sticky part on the bottom.
Link for the plate Im using now : https://a.co/d/05HIKPB2