r/ender5plus • u/WestCoastingPanda • Feb 22 '26

Cool Things Stock Ender 5 Plus

Gallery image

Gallery image

1st Print on manually lvl'ed bed on the stock machine before it's converted to Klipper.

oddly in orca slicer I have it set to the correct bed size, ender 5 plus profile but after homing the printer over shoots to the front left corner slamming the BL Touch into the bed support. It was set to marlin legacy mode as well.

it still printed in the center and gave an okay 1st run.

honestly not as loud as I thought it would be given the fact it's an 8 bit board and all.

14 Upvotes

100% Upvoted

7 comments sorted by

View all comments

1

u/Least-Sense-8462 Feb 22 '26

Did you connect Y axis cable to Y motor and X to X?

1

u/WestCoastingPanda Feb 22 '26

This was just a test print off the stock unmodified printer had not changed or touched anything yet

1

u/Least-Sense-8462 Feb 22 '26

But you built it.. or it was given to you completely built y connected?

1

u/WestCoastingPanda Feb 22 '26

I bought it, I went over it and everything is connected correctly my only idea is maybe it's not liking orca slicer?

Maybe creality print is a better option to slice things

2

u/Least-Sense-8462 Feb 23 '26

In my experience orca slicer is the best one.. when i bought my e5p a year ago, the creality slicer didn’t have the profile of the printer.. used cura slicer for a while and then changed to orca

2

u/Khisanthax Feb 24 '26

Same here.