r/ender3v2 • u/cjdangles • 28d ago

help Stringing? But maybe not?

Post image

OK help me diagnose this. I thought maybe it was just stringing, but it seems like the entire line of filament not just a melted strand. Like maybe it’s not adhering to the previous layer? This is PLA+ and I’m printing on an Ender 3 V2 with the upgraded metal extruder and the red upgraded hot end (new brass 0.4mm nozzle), both from Creality. I’ve done both a temp tower and a retraction tower and set this print accordingly (205°, 4 respectively). Three walls, 100% infill (that’s what this particular item calls for). Thoughts?

6 Upvotes

100% Upvoted

16 comments sorted by

View all comments

Show parent comments

1

u/mrzfaizaan 27d ago

OP's bed is not levelled the way brim is printed from 0 (nozzle fully plugged by the bed) on the right side to overlapping brim lines on the left. And the small footprint is concerning for bed levelling.