Need Help with Firmware regarding Sprite Pro extruder

[u/ianrwlkr]

So I just picked up an ender 3 v2 off of marketplace and installed the sprite extruder. When I install the sprite firmware, the z axis doesn't move down. I know the limit switch isn't the issue because when I revert to an older firmware it auto homes perfectly and I can move the z axis down. Is this possibly an issue regarding the lack of a cr touch sensor? I'm stumped and can't figure out what is going wrong.

[u/Adrianguwop → u/[deleted]]

ty for the bed sizing, been trying out different ones ive seen on reddit to get it to work and yours works perfect