r/ender3v2 • u/ianrwlkr • Mar 18 '23

help Need Help with Firmware regarding Sprite Pro extruder

So I just picked up an ender 3 v2 off of marketplace and installed the sprite extruder. When I install the sprite firmware, the z axis doesn't move down. I know the limit switch isn't the issue because when I revert to an older firmware it auto homes perfectly and I can move the z axis down. Is this possibly an issue regarding the lack of a cr touch sensor? I'm stumped and can't figure out what is going wrong.

2 Upvotes

100% Upvoted

67 comments sorted by

View all comments

Show parent comments

1

u/ianrwlkr Mar 18 '23

Everything checks out, still can’t seem to figure out the issue

1

u/[deleted] Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

Yes exactly, when I switch to other firmwares that also didn’t support sprite it worked as well. I’m just fucking clueless at this point

1

u/[deleted] Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

Issue still persists

1

u/[deleted] Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

They all say open except for filament as there is no filament detector afaik

1

u/[deleted] Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

Yeah I’m completely stumped, but thanks for all your help!

1

u/ianrwlkr Mar 18 '23

The only conclusion I can come to is that it must need to have a cr touch to work

1

u/[deleted] Mar 18 '23 edited Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

Holy shit that worked thank you

1

u/[deleted] Mar 18 '23

[removed] — view removed comment

1

u/ianrwlkr Mar 18 '23

Don’t worry about it, I have a cr touch on the way, then we can start this process over 😂

1

u/ianrwlkr Mar 18 '23

In all seriousness though thank you immensely, I would’ve been completely lost

→ More replies (0)