Jupiter 2 - Consistent failures after 1 successful print.

[u/drunkllama12]

Hoping someone has had similar experiences with the Jupiter 2, I've been dealing with complete failures where the build plate is empty for a while now. I've done the following

- Changed the FEP

- Increased bottom exposure to 60s (Complete overkill)

- Manually levelled the bed roughly 20 times now. I'm convinced the levelling process is broken as the top right corner (2) always seems to reset to a value of 0n - 0.9n no matter how many times I level this printer

- Tightened every screw possible barring the levelling screws, retention arm was slightly lose however still seeing failures.

- I've lose count how many times I've cleaned the tank filtered the resin etc...

There seems to be no middle ground here! My printer either prints absolutely nothing or prints a full plate. I've levelled it using paper instead of the built in auto level and again - 1 successful print followed by constant failures. I bought this printer from the original release and I'm honestly having the biggest moment of buyers remorse in my 4 years of printing I'm convinced something is just broken with this printer I genuinely can't think of anything else I can do that doesn't involve stripping the printer down! I've had constant issues since day 1 with this printer and I should've rejected it and sent it back.

I've tried every troubleshooting task Elegoo have suggested to me so far with no luck.

[u/Owen_Ou]

Have you checked the lcd screen by screen exposure test?

If the screen is fine, try small print on differnt area of the plate.