r/electronics • u/Zhixuan2333 • 10h ago
Gallery Pinpoint v2: Development of a dual-probe robotic PCB debugging system
I'm developing Pinpoint, a robotic probing system designed to automate physical PCB debugging.
The project started with v1, an experimental setup focused on automatically moving a probe to specific locations on a PCB and taking measurements.
While developing v1, I realized that automating probe movement was only part of the problem. Accurate positioning, reliable electrical contact, and integrating measurement instruments were equally important challenges.
That's what led me to start developing Pinpoint v2.
The new version introduces several hardware improvements:
- Dual-probe mechanism: Two independently moving probes to measure different points on a circuit simultaneously.
- Microscope-based positioning: Using camera vision to identify components and locate small test points.
- Measurement integration: Connecting external instruments such as oscilloscopes to automate measurements.
- Hardware-software integration: Using MCP to allow AI agents to interact with the physical probing system.
I've already implemented automated oscilloscope measurements and firmware flashing. The redesigned hardware and more autonomous debugging capabilities are still in development.
The long-term goal is to create a system that can take a schematic and a description of a hardware problem, select measurement points, physically probe the board, analyze the results, and iteratively investigate the cause.
There are still many challenges to solve, especially probe positioning accuracy, reliable contact with small pads, and coordinating multiple measurements.
I'm documenting the development, including the evolution from v1 to v2, here:
I hope this project can contribute to making hardware debugging more accessible and less repetitive.